X-Amp
Reamp Box
From Radial Engineering:
The Radial X-Amp™ is an active Reamper™ that allows the engineer to play a pre-recorded track back through guitar amplifiers and pedals. This opens the door to new possibilities and enhances the creative process so that your recording stands out.
Following the critically acclaimed Radial JD7™ Injector, the X-Amp employs a unique class-A circuit design that has been optimized for use with guitars. Features include balanced line level input with LED peak indicator and level control, class-A circuit topology for optimal reach and frequency response, a transformer isolated output to eliminate hum and buzz caused by ground loops, a 180° polarity reverse switch to bring both amps into phase, and a dual ground lift switch for noise-free operation.
To Reamp, start by recording a dry track using a Radial J48 and splitting the signal. Record the wet track using a mic so that the guitarist can hear it. Send him to the beach!
Specs
- Audio circuit type
- 100% discrete class-A
- Frequency response
- 20Hz ~ 15kHz (± 1.0dB)
- Dynamic range
- 119dB
- Total harmonic distortion
- 0.02% @ -15dBu
- Intermodulation distortion
- 0.02% @ -20dBu
- Input impedance
- 600Ω
- Noise floor
- OUT-1 -110dB; OUT-2 -108dBu
- Maximum input
- +22dBu
- Features
- 180° polarity reverse, Ground lift, Level Control
- Input connectors
- XLR
- Output connectors
- 1/4" Isolated and Direct
- Construction
- 14 gauge steel chassis & outer shell
- Size (L x W x D)
- 3.3" x 5.0" x 2" (84 x 127 x 48mm)
- Weight
- 1.55lb (720g)
- Power
- +15VDC/400mA adapter included
- Conditions
- For use in dry locations only between 5°C and 40°C
Source: Radial X-Amp specifications page